Fastest way to Airbrush a Surfboard

1 ANSWERS

1. Guest4924
   

    Whether you have bought into the time to make your own surfboard or you just desire to give your vintage surfboard a facelift, airbrushing it is an perfect and cheap way to make your surfboard exclusively your own. Always airbrush your board over the sanded fiberglass. Make certain you use ink or decorate that is intended for surfboards so you don't wreck the finish. Keep the decorate you use for touch-ups or faded spots.
   
   • Design what you desire to decorate on your board with the marker on a large part of paper. You can conceive your own or gaze for ready-made stencils. If this is your first time airbrushing, hold the design simple.
   
   • Cut out and strip the stencil on the board where you desire the conceive to be. You can replicate the convention or image on diverse locations on the board. Just make some exact replicates of the stencil and strip them on the board.
   
   • Tape off the localities not being decorated with the masking tape. Make certain to cover all localities not being painted. If you lay the strip in a convention, it adds to the attractiveness of the decorate job.
   
   • Fill the airbrush with the ink as asserted by the manufacturer's directions. Make certain the ink is conceived expressly for airbrushes and is matching with the complete of your board.
   
   • Attach the brush to the air supply. Read all main headings that arrive with the owner's manual to manage so.
   
   • Practice utilising the brush on cancels of piece of cloth, timber or plastic. Make certain you are snug retaining and utilising the brush before you trial this on your board. Put on the security mask even while practicing. Once you seem snug with the airbrush, proceed to your board.
   
   • Start with backdrop colors. Spray the ink at a 45-degree angle. Do not use too much. One outer garment of squirt should do. Make certain that no strip obscures the components of the stencil to be painted.
   
   • Begin squirting the stencil. You manage not have to concern about squirting after the stencil if the localities round it are methodically taped. Use a lightweight digit on the initiate and manage not use more than one coat.
   
   • Allow the ink to dry as asserted by the manufacturer's instructions. Gently peel the strip off the board. Remove the stencils. Put a outer garment of sealer on peak for a glossier finish.

   Report (0) (0)  |   12 years, 7 month(s) ago