My s120eth sub woofer is On but there is no sound.

1 ANSWERS

1. Guest8126
   

   There are some procedure and steps which you need to take in order to make sure that you have taken so that you can your sound system smoothly and efficiently.
   
   First of all you have to know your speaker system very well in order to understand and develop thorough knowledge to make it able to connect and sync with the pc. Normally the speaker system comes with a subwoofer and a set of wires to connect, which has different other equipments such as a power cord to connect the system to the AC outlet. It also has a power connector which provides and supplies power to the subwoofer and the subwoofer wires. There should be three set of cables which are needed to connect the speaker system to your pc. These cables are of different colors for your convenience so that we can differentiate between them.
   
   Your first task to check is that the cables are connected to the proper sockets and to the proper location. Then you can connect other cables like power, subwoofer and speakers. This can be done by following the parity numbers which are written on the connectors. After following all these steps your cables should be connected properly to the audio system and cabling is done correctly.
   
   For every single connection that has been made, it is now time to setup audio configuration in the audio system. In case of Realtec drivers on the PC, you can open up speaker configuration tab and in that tab you can select 6 channel mode for 5.1 speaker output and for the setting of rear and center subwoofers you have to check outputs so that it is sure that all the software offers compliance with the hardware and the speaker system of your woofer.
   
    

   Report (0) (0)  |   12 years, 9 month(s) ago