were is the rear heat acuator location

1 ANSWERS

1. amomipais82
   

   Hi There,
   There is a blend door actuator that is possibly not working. It is separate from the rear heat system. Here's what I have on that:
   
   The A/C electric blend door actuator is located on the plenum assembly.
   
   
   Its function is to move the air temperature blend door on command from the control assembly.
   The A/C electric blend door actuator contains a reversible electric motor and a potentiometer. The potentiometer wiper is connected to the actuator output shaft and moves with the output shaft to indicate the position of the air temperature blend door.
   A 5 volt signal is applied to the ends of the potentiometer. The voltage available at the wiper indicates the position of the potentiometer. The expressed value of the actuator wiper voltage is sent to the EATC module and is compared to the desired wiper voltage determined by the EATC module. The control module then drives the actuator motor in whichever direction is necessary to make the actuator wiper voltage agree with the desired wiper voltage.
   
   The wiper they refer to is door itself.

   Report (0) (0)  |   12 years, 9 month(s) ago