no second gear and no reverse in 46 re transmission

1 ANSWERS

1. amomipais82
   

   Hi,
   I have fixed the issue completely with my shifter and it works beautifully now! Note the first picture here i have soldered a wire from an old non working wheel across the broken PCB circuit in effect bypassing it and completing the required circuit.
   
   I did this so the board is still replacable if for some reason i still need to unplug this and stick another one in its place.  Then i just tie wrapped the extra wire out of the way....if you have smaller fingers you can just cut the wire just long enough to go between the 2 poles, but alas i am cursed with fat fingers :P Before reassembling the entire shifter i checked continuity at the end of the plug where it attaches to the PCB on the back of the PCB that holds all of the extra buttons with the shifter in reverse position and it now had continuity  Plugged it back in and everything works great as seen in the 2nd picture Reverse position now shows up as reverse gear instead of a second 6th gear .
   Thanks

   Report (0) (0)  |   12 years, 8 month(s) ago