Looking for the information about Backflush a Pool

1 ANSWERS

1. Guest9035
   

    Backflushing a bathing pool cleans the sand held in the pool's filter. Backflushing, furthermore renowned as backwashing, determinants water to run through the filter in a way that mixes up the sand newspapers in the container, initiating debris and lesser dirt to journey with the water out the filter's waste line. Backwashing normally needs that the filter be rinsed in alignment to avert sand from getting away the filter one time usual filtration is resumed.
   
   • Turn off the propel scheme that proceeds water to the filter. Move the filter's handle from the "Filter" setting to the "Backwash" setting.
   
   • Unravel any backwash hose adhered to the filter and location it on the ground beside a apt drainage area. Turn on the propel scheme and hold the filter running for two to three minutes, or until the water going out of the backwash line is clear.
   
   • Shut off the propel scheme and turn the filter handle to the "Rinse" setting. Run the filter on "Rinse" for not less than 30 seconds to permit the sand in the filter to settle. Shut off the propel system.
   
   • Move the filter handle from the "Rinse" to the "Filter" setting. Run the propel and observe the pool comes back, looking for any sand coming back to the pool. If sand arrives from the pool comes back, rinse the filter one time more.

   Report (0) (0)  |   12 years, 7 month(s) ago