siemens dishwasherr se25a266 atuck on 1 minute

1 ANSWERS

1. amomipais82
   

   Hi There,
   Be aware that you should remove dishwasher's power cable before touching wires or making resistance measuring !!!
   Check that the inlet valve get power. In case it does and no water
   entering the tub, check with multi-meter for solenoid's resistance (disconnect first the wires to it),if no measurement result, you should replace the valve.
   In case you have a measurement result, remove the solenoid from the valve and check that it's clean from any dirt.
   In case there is no power to the inlet valve - check that the float switch works. This is usually a small switch attached to a float. The float (usually a cylindrical) located inside the dishwasher at the bottom. As the water level rises, the float rises too. When it reaches the certain height, the float activates its switch, which cuts the electricity to the water inlet valve. If the switch is defective (stuck in the disconnected position)it will prevent power from the inlet valve.
   The switch is an On/Off switch and you can check it easily by a multi-metr.
   Good luck !!

   Report (0) (0)  |   12 years, 9 month(s) ago